192.168.1.1-路由器设置 | 192.168.0.1-无线路由器设置

华为路由产品的vlan划分、单臂路由以及静态路由

发布时间:2012-12-13 10:41
这是一个关于华为路由产品的vlan划分、单臂路由以及静态路由使所有成员都能上网的实验。
拓扑图如下:
 
 
IP地址规划如图!
给三台电脑配IP地址
 
 VLAN 划分:
 
<Huawei>sy         进入视图模式
[Huawei]un in en      关闭消息中心
[Huawei]sysname SW1      改交换机名字
[SW1]inter vlan 1       进入交换机
[SW1-Vlanif1]ip address 192.168.0.10 24   ip地址
[SW1-Vlanif1]un shut    开启
[SW1]vlan 2     设置vlan
[SW1-vlan2]vlan 3
[SW1-vlan3]vlan 4
[SW1]inter e0/0/2    进接口 划分vlan
[SW1-Ethernet0/0/2]port link-type access     
[SW1-Ethernet0/0/2]port default vlan 3
[SW1-Ethernet0/0/2]inter e0/0/1
[SW1-Ethernet0/0/1]port link-type access
[SW1-Ethernet0/0/1]port default vlan 2
[SW1-Ethernet0/0/1]inter e0/0/3
[SW1-Ethernet0/0/3]port link-type access
[SW1-Ethernet0/0/3]port default vlan 4
[SW1-Ethernet0/0/3]inter g0/0/1
[SW1-GigabitEthernet0/0/1]port link-type trunk  设置成中端口
[SW1-GigabitEthernet0/0/1]port trunk allow-pass vlan all
设置成所有成员通过
 
单臂路由:
<Huawei>sy    进入视图模式
[Huawei]un in en   关闭消息中心
[Huawei]sysname R1  改交换机名字
[R1]inter g0/0/0
[R1-GigabitEthernet0/0/0]un shut   开启
[R1-GigabitEthernet0/0/0]inter g0/0/0.1  进入子接口
[R1-GigabitEthernet0/0/0.1]dot1q termination vid 1
[R1-GigabitEthernet0/0/0.1]ip address 192.168.0.1 24
[R1-GigabitEthernet0/0/0.1]un shut
[R1-GigabitEthernet0/0/0.1]inter g0/0/0.2
[R1-GigabitEthernet0/0/0.2]dot1q termination vid 2
[R1-GigabitEthernet0/0/0.2]ip address 192.168.1.1 24
[R1-GigabitEthernet0/0/0.2]un shut
[R1-GigabitEthernet0/0/0.2]inter g0/0/0.3
[R1-GigabitEthernet0/0/0.3]dot1q termination vid 3  
[R1-GigabitEthernet0/0/0.3]ip address 192.168.2.10 24
[R1-GigabitEthernet0/0/0.3]un shut
[R1-GigabitEthernet0/0/0.3]inter g0/0/0.4
[R1-GigabitEthernet0/0/0.4]dot1q  termination vid 4     
[R1-GigabitEthernet0/0/0.4]ip address 192.168.3.10 24
[R1-GigabitEthernet0/0/0.4]un shut
[R1-GigabitEthernet0/0/0.4]inter g0/0/1
[R1-GigabitEthernet0/0/1]ip address 202.106.1.1 30  配置ip地址
[R1-GigabitEthernet0/0/1]un shut
 
<Huawei>sys
[Huawei]un in en 
[Huawei]sysname R2
[R2]inter g0/0/0
[R2-GigabitEthernet0/0/0]ip address 202.106.1.2 30
[R2-GigabitEthernet0/0/0]un shut
[R2-GigabitEthernet0/0/0]inter g0/0/1
[R2-GigabitEthernet0/0/1]ip address 202.106.1.5 30
[R2-GigabitEthernet0/0/1]un shut
 
<Huawei>sy
[Huawei]un in en
[Huawei]sysname R3
[R3]inter g0/0/0
[R3-GigabitEthernet0/0/0]ip address 202.106.1.6 30
[R3-GigabitEthernet0/0/0]un shut
 
 
加静态路由:
[R2]ip route-static 192.168.0.0 255.255.252.0 202.106.1.1  然后测试结果
 
[R3]ip route-static 202.106.1.0 30 202.106.1.5
[R3]ip route-static 192.168.0.0 22 202.106.1.5
[R1]ip route-static 202.106.1.4 30 202.106.1.2
 
 
测试结果,都通了!
关于我们 - RSS地图 - 最近更新 - 友情链接 - 网站地图 - 版权声明